Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release retaining clip -3- in direction of -arrow- and disconnect
washer fluid hose -2- from windscreen washer jet.
– Unplug electrical connector -1- if fitted.
Installing
Installation is carried out in the reverse order; note the following:
– When fitting washer fluid hose, make sure that retaining clip
engages audibly in connection on washer fluid hose.
– Insert washer jet in bonnet.
3.4 Adjusting washer jets
– Adjust washer jets for windscreen washer system ⇒ Mainte‐
nance ; Booklet 404 ; Maintenance; Windscreen washer
system: checking spray pattern and adjusting if necessary .
– If spray pattern does not match specifications, clean the con‐
taminated washer jet.
Cleaning washer jet:
Caution
Risk of damage.
♦ Do NOT use any tools or implements to clean the washer
jets.
– Remove washer jet - vehicles up to 08.2007 ⇒ page 121 .
– Remove washer jet - vehicles from 09.2007 onwards
⇒ page 121 .
– Rinse washer jet with clear water in opposite direction of spray.
– Always blow through washer jet in opposite direction of spray
when removing remaining particles of dirt by applying com‐
pressed air.
– If spray pattern still does not match specifications, renew
washer jet.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
122 Rep. gr.92 - Windscreen wash/wipe system
To Next Page
Loading...
