Audi 2003 A8 - Removing and Installing Dynamic Cornering Light Control Motor V318; V319; Removing and Installing Headlight Range Control Motor V48; V49

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Switch off ignition and all electrical equipment and remove ig‐
nition key.
– Do not flash the headlights.
– Loosen locking bolt -1- a few turns.
– Remove appropriate front wheel.
– Remove relevant front wheel housing liner ⇒ Rep. gr. 66 .
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
– Pull bulbs -arrows- out of housing.
– Unplug electrical connector at bulb.
Installing
Installation is carried out in the reverse order; note the following:
– Press bulb holder into reflector until you feel it engage.
– Close housing cover and secure with locking bolt.
– Install front wheel housing liner ⇒ Rep. gr. 66 .
5.16 Removing and installing dynamic cor‐
nering light control motor -V318- / -
V319-
The dynamic cornering light control motor is located in the head‐
light housing and cannot be renewed separately in the event of a
fault.
– Renewing headlight ⇒ page 179 .
5.17 Removing and installing headlight range
control motor -V48- / -V49-
Removing
WARNING
High voltage! Danger to life!
♦ Ensure that any part of the gas discharge headlights
marked with yellow high-voltage warning symbols are de-
energised when you are working on them.
♦ Switch off ignition and all electrical equipment and remove
ignition key.
♦ Do not flash the headlights.
– Turn light switch to position “0”.
– Switch off ignition and all electrical equipment and remove ig‐
nition key.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
5. Gas discharge headlights - USA vehicles 193