Audi 2003 A8 - Inner Tail Light Cluster - Vehicles from 09.2007 Onwards; Inner Tail Light Cluster - Exploded View; Removing and Installing Inner Tail Light Cluster

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
19 Inner tail light cluster - vehicles from
09.2007 onwards
Observe notes on contact corrosion ⇒ page 125 .
19.1 Inner tail light cluster - exploded view
1 - Tail light
❑ Removing and installing
⇒ page 236
❑ Aligning with body con‐
tour ⇒ page 239
2 - Bulb for rear fog light
❑ 12 V, 19 W
❑ Removing and installing
⇒ page 238
3 - Bolt
❑ 1 Nm
4 - Bolt
❑ 1 Nm
5 - Housing cover
❑ For tail light cluster
6 - Bolt
❑ 1 Nm
7 - Reversing light bulb
❑ 12 V, 16 W
❑ Removing and installing
⇒ page 237
8 - Nut
❑ 3 Nm
9 - Centre hex stud with hexa‐
gon head
❑ With sealing washer
❑ For aligning tail light
cluster with body con‐
tour
19.2 Removing and installing inner tail light
cluster
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Remove rear lid trim ⇒ Rep. gr. 70 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
236 Rep. gr.94 - Lights, bulbs, switches - exterior