Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unplug electrical connector -arrow- at engine mounting (left-
side).
– Unscrew bolts -1 ... 4- and detach engine support with engine
mounting.
– Unscrew earth wire -4- at starter.
– Detach electrical wires -2- and -3- at starter.
– Unscrew bolts -1- and -5- and remove starter.
Installing
Installation is carried out in the reverse order; note the following:
– Install engine ⇒ Rep. gr. 10 .
Tightening torques
Component Nm
Starter to gearbox M10x40 45
M10x135
1)
65
Terminal B+ to starter 16
Earth cable to starter 22
Engine support to cylinder block 40
•
1)
Bolt strength rating 10.9.
5.5 Vehicles with 6.0 ltr. MPI engine
Removing
• Engine/gearbox assembly removed and secured to scissor-
type assembly platform - VAS 6131- ⇒ Rep. gr. 10 .
– Unscrew bolts -arrows- at front gearbox mounting (left and
right).
Audi A8 2003 ➤
Electrical system - Edition 08.2014
74 Rep. gr.27 - Starter, current supply, CCS
To Next Page
Loading...
