Audi 2003 A8 - Removing and Installing Front Exterior Door Handle Switches F272; F273; Removing and Installing Rear Exterior Door Handle Switches F274; F275; Removing and Installing Interior Aerial 1 for Entry and Start Authorisation R138

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
❑ Rear right door exterior handle touch sensor - G418- , rear left door exterior handle touch sensor - G417-
❑ Cannot be renewed separately
❑ Renewing exterior door handle ⇒ Rep. gr. 58
10.4 Removing and installing front exterior
door handle switches -F272- / -F273-
Removing
– Remove exterior door handle ⇒ Rep. gr. 57 .
– Remove mounting bracket ⇒ Rep. gr. 57 .
– Carefully release retaining clip -2- in direction of -arrow A- and
detach front exterior door handle switch -1- from mounting
bracket -3- -arrow B-.
Installing
Installation is carried out in the reverse order; note the following:
– Install mounting bracket ⇒ Rep. gr. 57 .
– Install exterior door handle ⇒ Rep. gr. 57 .
10.5 Removing and installing rear exterior
door handle switches -F274- / -F275-
Removing
– Remove exterior door handle ⇒ Rep. gr. 58 .
– Remove mounting bracket ⇒ Rep. gr. 58 .
– Carefully release retaining clip -2- in direction of -arrow A- and
detach front exterior door handle switch -1- from mounting
bracket -3- -arrow B-.
Installing
Installation is carried out in the reverse order; note the following:
– Install mounting bracket ⇒ Rep. gr. 58 .
– Install exterior door handle ⇒ Rep. gr. 58 .
10.6 Removing and installing interior aerial 1
for entry and start authorisation - R138-
Removing
– Switch off ignition and take out ignition key.
– Press button -arrow- and take out front ashtray insert -1-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
10. Entry and start authorisation system 311