Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8 Fog lights - vehicles from 09.2007 on‐
wards
8.1 Removing and installing fog lights
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Release retaining tabs -1- and -2- and pull out air inlet grille in
lower section of bumper cover -arrow-.
– Unscrew bolts -arrows- and take fog light housing -1- out of
bumper cover.
– Unplug electrical connector.
Installing
Installation is carried out in the reverse order; note the following:
Note
Position washers between fog light housing and bumper cover
when positioning outer bolts.
– Adjust fog lights ⇒ page 206 .
Tightening torque
Component Nm
Fog light housing to bumper cover 2.3
8.2 Renewing fog light bulb
Removing
– Remove fog light ⇒ page 205 .
– Turn bulb -1- anti-clockwise -arrow- and pull it out of fog light
housing.
Installing
Installation is carried out in the reverse order; note the following:
– Do not touch glass bulb with bare hands.
– Secure bulb by turning in clockwise direction.
– Adjust fog lights ⇒ page 206 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
8. Fog lights - vehicles from 09.2007 onwards 205

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English