Audi 2003 A8 - Lights and Switches in Front Doors; Removing and Installing Bulb for Door Opener Light; Removing and Installing Mirror Adjustment Switch E43

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3 Lights and switches in front doors
Observe notes on contact corrosion ⇒ page 264 .
3.1 Removing and installing bulb for door
opener light
Removing
– Remove relevant door trim ⇒ Rep. gr. 70 .
– Unplug electrical connectors -1- and -2-.
– Unscrew bolts -arrows- and detach door opener.
– Turn bulb holder -1- to left and pull out at door opener -2-.
Installing
Installation is carried out in the reverse order; note the following:
– Insert bulb for door opener light in opening and engage.
– Install door trim ⇒ Rep. gr. 70 .
3.2 Removing and installing mirror adjust‐
ment switch - E43-
Removing
– Switch off ignition and take out ignition key.
– Remove door trim (front) ⇒ Rep. gr. 70 .
– Detach insulating mat from door trim.
– Unscrew bolts -arrows- and detach armrest.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
270 Rep. gr.96 - Lights, bulbs, switches - interior