Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolts -1- and -2-.
– Turn fog light housing -3- anti-clockwise on left-side of vehicle
-arrow- and clockwise on right-side.
– Take fog light housing out of bumper cover.
– Unplug electrical connector.
Installing
Installation is carried out in the reverse order; note the following:
– Adjust fog lights ⇒ page 204 .
Tightening torque
Component Nm
Fog light housing to bumper cover 1.5
7.5 Renewing fog light bulb - Audi S8
Removing
– Remove fog light ⇒ page 202 .
– Release retaining tabs -arrows- on cover cap -1-.
– Unplug electrical connector -2- at bulb.
– Disengage retaining clip -1- and take bulb -3- out of housing.
Installing
Installation is carried out in the reverse order; note the following:
– Fit new bulb (H7 - 12 V, 55 W – W5W Longlife) in housing; do
not touch the glass part of the bulb with bare hands.
– Secure bulb with retaining clip.
– Plug in connectors and close housing cover.
– Adjust fog lights ⇒ page 204 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
7. Fog lights - vehicles up to 08.2007 203