Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Removal lever - 80 - 200-
Removing
– Switch off ignition and take out ignition key.
– Use removal lever - 80 - 200- to prise cover grille with high-
level brake light out of rear shelf -arrow 1-.
– Pull out cover grille to front -arrow 2-.
– Unplug electrical connector at high-level brake light.
– Unplug electrical connector -1-.
– Press out spring pins -2- of fasteners.
– Lift warning buzzer out of luggage compartment partition.
Installing
Installation is carried out in the reverse order; note the following:
– Unfasten lining for luggage compartment partition on rear
edge.
– Press spring pins into fasteners.
24.6 Removing and installing front parking
aid senders - vehicles with twin grille
♦ Fitting location: in bumper cover -arrows-.
Removing
Outer senders:
– Remove bumper cover ⇒ Rep. gr. 63 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
258 Rep. gr.94 - Lights, bulbs, switches - exterior