Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove relevant front wheel housing liner ⇒ Rep. gr. 66 .
– Loosen locking bolt -1- a few turns.
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
– Turn bulb holder anti-clockwise -arrow- and pull out of head‐
light housing.
– Pull bulb -1- for dipped beam headlights out of bulb holder
-2-.
Installing
Installation is carried out in the reverse order; note the following:
– Insert new bulb in bulb holder, taking care not to touch glass
bulb with bare hands.
– Secure bulb holder by turning clockwise.
– Close housing cover and secure with locking bolt.
– Install front wheel housing liner ⇒ Rep. gr. 66 .
3.6 Renewing bulb for main beam head‐
lights
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
Headlight (left-side):
– Remove power steering reservoir ⇒ page 141 .
Headlight (right-side):
– Remove air cleaner (top section) ⇒ page 142 .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Halogen headlights (USA vehicles) 143
To Next Page
Loading...
