Audi 2003 A8 - Removing and Installing Washer Jets - Vehicles up to 08.2007; Removing and Installing Washer Jets - Vehicles from 09.2007 Onwards

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.2 Removing and installing washer jets -
vehicles up to 08.2007
Removing
– Unclip washer jets from underneath bonnet -arrow-.
– Detach washer fluid pipe -1- at unclipped washer jet.
– Unplug electrical connector -2-.
Installing
Installation is carried out in the reverse order; note the following:
– When installing, make sure that the water hose audibly en‐
gages in the connection on the washer jet.
– Insert washer jet in bonnet.
• Oval opening -arrow- for individual washer jet must face outer
side of vehicle.
3.3 Removing and installing washer jets -
vehicles from 09.2007 onwards
Removing
– Unclip washer jets -1- from underneath bonnet -arrow-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Windscreen washer system 121