Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Note
B+ wire can only be disconnected after unplugging connector for
terminal 50.
– Unscrew earth cable -1-.
– Detach electrical wiring -3- and -4-.
– Unscrew bolts -2- and -5- and remove starter.
Installing
Installation is carried out in the reverse order; note the following:
Note
Refit all cable ties at the same locations when reinstalling.
– Install engine cross member and subframe ⇒ Rep. gr. 40 .
– Install engine support ⇒ Rep. gr. 10 .
– Install anti-roll bar ⇒ Rep. gr. 40 .
– Connect battery. Steps required ⇒ page 3 .
Tightening torques
Component Nm
B+ wire to starter 16
Starter to gearbox
M10
1)
65
M12 65
Heat shield to gearbox 23
Bracket with ATF cooler to body 9
•
1)
Bolt strength rating 10.9.
5.4 Vehicles with 5.2 ltr. FSI engine
Removing
– Remove engine ⇒ Rep. gr. 10 .
– Engine/gearbox assembly remains on scissor-type assembly
platform - VAS 6131- .
– Unscrew bolt -arrow-.
– Detach retainer for connectors -1 ... 4- from subframe.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
72 Rep. gr.27 - Starter, current supply, CCS
To Next Page
Loading...
