Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2 Removing and installing light switch
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Press light switch -arrow 1- and simultaneously turn it clock‐
wise -arrow 2-.
– Hold switch in this position and pull light switch out of switch
housing -arrow 3-.
– Unplug electrical connector.
Installing
Installation is carried out in the reverse order; note the following:
– Press switch into switch housing until catch engages.
2.3 Removing and installing steering col‐
umn adjustment switch - E167-
Special tools and workshop equipment required
♦ Special screwdriver T8 - T40056 A-
Removing
WARNING
When working on knee airbag, observe safety precautions for
working on airbags ⇒ Rep. gr. 69 .
– Remove driver's storage compartment ⇒ Rep. gr. 68 .
– Move steering wheel down and to rear as far as possible,
making use of full range of steering column adjuster.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
266 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
