Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unscrew nut on entry and start authorisation switch - E415-
using socket tool - T10152- .
– Take switch to rear out of driver's storage compartment.
Installing
Installation is carried out in the reverse order; note the following:
– Note correct position of entry and start authorisation switch -
E415- in relation to driver's storage compartment.
• Lug -1- facing upwards
– Hand-tighten nut using socket tool - T10152- .
– Note correct position of trim ring on entry and start authorisa‐
tion switch.
• Lugs -3- must engage in recesses -2- at switch.
– Install driver's storage compartment ⇒ Rep. gr. 68 .
23.2 Pin assignment at entry and start au‐
thorisation switch - E415-
1 - Switching matrix S2
2 - Ignition key withdrawal lock solenoid
3 - Terminal 31
4 - Immobiliser serial clock
5 - Switching matrix S1
6 - Switching matrix S6
7 - Switching matrix S3
8 - Immobiliser Data 2
9 - 12 V
10 - Switching matrix S5
11 - Switching matrix S4
12 - Immobiliser Data 1
Audi A8 2003 ➤
Electrical system - Edition 08.2014
254 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
