Audi 2003 A8 - Removing and Installing Parking Aid Control Unit J446 (Vehicles up to 11.2005)

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Fitting location for parking aid button - E266-
♦ In centre console switch unit
♦ Removing and installing ⇒ page 267 .
24.2 Removing and installing parking aid
control unit - J446- (vehicles up to
11.2005)
Removing
– If control unit is to be renewed, select the “Replace control unit”
function for appropriate control unit in ⇒ Vehicle diagnostic
tester.
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
– Switch off ignition and take out ignition key.
– Remove cover for luggage compartment side trim (left-side)
-arrows-.
– Unscrew nuts -arrows-.
– Unplug electrical connectors -2-.
– Detach parking aid control unit - J446- -item 1-.
Installing
Installation is carried out in the reverse order; note the following:
Tightening torque
Component Nm
Control unit to body 2
Audi A8 2003 ➤
Electrical system - Edition 08.2014
256 Rep. gr.94 - Lights, bulbs, switches - exterior