Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
All vehicles (continued):
– Release retaining tabs -arrows- and detach main beam hous‐
ing cover from headlight housing.
– Pull bulb holder -arrow- for side light bulb out of housing.
– Pull bulb for side lights out of bulb holder.
Installing
Installation is carried out in the reverse order; note the following:
– Insert new bulb in bulb holder, taking care not to touch glass
bulb with bare hands.
– Press bulb holder into reflector until you feel it engage.
– Close housing cover.
5.13 Removing and installing main and dip
beam switch-over solenoid -N347- / -
N348-
The main and dip beam switch-over solenoid is located in the
headlight housing beneath the gas-discharge lamp and cannot be
renewed separately in the event of a fault.
– Renewing headlight ⇒ page 179 .
5.14 Removing and installing swivel module
position sensor -G474- / -G475-
The swivel module position sensor is located in the headlight
housing beneath the gas discharge bulb and cannot be renewed
separately in the event of a fault.
– Renewing headlight ⇒ page 179 .
5.15 Renewing bulb for turn signal
Removing
WARNING
High voltage! Danger to life!
♦ Ensure that any part of the gas discharge headlights
marked with yellow high-voltage warning symbols are de-
energised when you are working on them.
♦ Switch off ignition and all electrical equipment and remove
ignition key.
♦ Do not flash the headlights.
– Turn light switch to position “0”.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
192 Rep. gr.94 - Lights, bulbs, switches - exterior

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English