Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
3.4 Removing and installing window regula‐
tor switch in front passenger door -
E107-
Removing
– Switch off ignition and take out ignition key.
– Remove door trim (front) ⇒ Rep. gr. 70 .
– Detach insulating mat from door trim.
– Unscrew bolts -arrows- and detach armrest.
– Unscrew bolt -arrow- and detach switch mounting -1- from
armrest.
– Unscrew bolts -arrows- and detach switch mounting with win‐
dow regulator switch.
– Unplug electrical connector -2-.
– Use small screwdriver to carefully release retaining hooks
-arrows-.
– Pull window regulator switch in front passenger door - E107-
-item 1- downwards out of switch mounting.
Installing
Installation is carried out in the reverse order; note the following:
– Press switch into switch mounting until retaining hooks en‐
gage.
– Install door trim (front) ⇒ Rep. gr. 70 .
3.5 Removing and installing driver side in‐
terior locking switch - E150- / front pas‐
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Lights and switches in front doors 273
To Next Page
Loading...
