Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
8 Components on interior mirror
Observe notes on contact corrosion ⇒ page 264 .
8.1 Removing and installing light sensor -
G399-
Special tools and workshop equipment required
♦ Improvised tool
– Use 0.7 mm thick metal strip to make suitable tool with dimen‐
sions in mm as shown in illustration.
Removing
– Guide offset end of improvised tool -1- under side of trim -2-
as shown in illustration.
– Release retaining tabs of trim by pulling improvised tool in di‐
rection of arrow.
– Repeat procedure on opposite side.
– Unplug electrical connector -1-.
– Press retaining clips together -arrows- and take light sensor -
G399- -item 2- out of mounting.
Installing
Install in reverse order.
8.2 Removing and installing humidity send‐
er - G355- - vehicles without lane depar‐
ture warning
Special tools and workshop equipment required
Audi A8 2003 ➤
Electrical system - Edition 08.2014
302 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
