Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Improvised tool
– Use 0.7 mm thick metal strip to make improvised tool with di‐
mensions shown.
Removing
– If control unit is to be renewed, select the “Replace control unit”
function for appropriate control unit in ⇒ Vehicle diagnostic
tester.
– Remove front interior light: vehicles up to 08.2007
⇒ page 292 , vehicles from 08.2007 onwards ⇒ page 293 .
– Remove interior mirror ⇒ Rep. gr. 68 .
– Unscrew bolts -arrows-.
– Unclip cover for centre bracket for sun visor and remove bolts.
– Take out centre bracket for sun visor.
– Guide offset end of improvised tool -1- under side of trim -2-
as shown in illustration.
– Release retaining tabs for trim by pulling improvised tool in
direction of -arrow-.
– Repeat procedure on opposite side.
– Unplug electrical connector -arrow- at front interior light.
– Guide out wiring for humidity sender - G355- between moul‐
ded headliner and body.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
8. Components on interior mirror 303
To Next Page
Loading...
