Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Use removal lever - 80 - 200- to carefully pry off cover panel
of interior light/reading light as shown.
– Insert removal lever - 80 - 200- between housing of interior
light/reading light and mounting frame in headliner as shown.
– Release retaining tabs -arrows- and take interior light/reading
light (rear) downwards out of opening in headliner.
– Press retaining tab -1- at multi-pin connector.
– Release retaining clips of connectors -arrow- and unplug con‐
nectors.
Installing
Installation is carried out in the reverse order; note the following:
– Insert rear interior light/reading light into roof trim and clip into
place.
7.9 Renewing rear interior light bulb - vehi‐
cles up to 08.2007
Special tools and workshop equipment required
♦ Removal lever - 80 - 200-
Audi A8 2003 ➤
Electrical system - Edition 08.2014
7. Lights and switches in roof trim 297
To Next Page
Loading...
