Audi 2003 A8 User Manual

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Holding at rear edge, pull side marker light out of bumper cover
-arrow-.
– Unplug electrical connector -1-.
Installing
Installation is carried out in the reverse order; note the following:
Note
The complete front side marker light must be renewed if the LED
is defective.
– Plug in electrical connector.
– Insert side marker light with retaining tab first in bumper cover
-arrow 1-.
– Press side marker light into bumper cover -arrow 2-.
6.2 Renewing side marker light bulb
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Release quick-release fasteners -1- and -2- and take off noise
insulation.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
6. Side marker light (USA vehicles) 199

Audi 2003 A8 Specifications

General

Brand	Audi
Model	2003 A8
Category	Automobile
Language	English