Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
senger side interior locking switch -
E198-
Removing
– Switch off ignition and take out ignition key.
– Remove relevant door trim ⇒ Rep. gr. 70 .
– Unplug electrical connector -2-.
– Release retainers -arrows- and press central locking switch
out of door trim towards passenger's compartment.
Installing
Installation is carried out in the reverse order; note the following:
– Install door trim ⇒ Rep. gr. 70 .
3.6 Removing and installing interior door
lighting strip
Special tools and workshop equipment required
♦ Removal wedge - 3409-
Removing
– Remove door trim ⇒ Rep. gr. 70 .
– Unplug electrical connectors -1- and -2-.
– Unscrew bolts -arrows- and detach door opener.
– Unplug electrical connector -1-.
– Carefully press lighting strip -2- out of door trim on back
-arrow-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
274 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
