Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Use removal wedge - 3409- -item 1- to carefully prise lighting
strip out of retaining clips.
Installing
Installation is carried out in the reverse order; note the following:
– Install door trim ⇒ Rep. gr. 70 .
3.7 Removing and installing switch panel
with rear lid remote release button -
E233- and fuel tank flap release button
- E319-
Removing
– Switch off ignition and take out ignition key.
– Remove door trim (front) ⇒ Rep. gr. 70 .
– Detach insulating mat from door trim.
– Unscrew bolts -arrows- and detach loudspeaker trim.
– Unplug electrical connector -1-.
– Unscrew bolts -arrows- and detach storage compartment from
door trim.
– Use Allen key to remove pin -1- for actuation of storage com‐
partment lock and pin -2- for stop.
– Repeat procedure on other side of storage compartment.
– Open storage compartment.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Lights and switches in front doors 275
To Next Page
Loading...
