Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7 Lights and switches in roof trim
Observe notes on contact corrosion ⇒ page 264 .
7.1 Removing and installing vanity mirror
light
Removing
– Use flat screwdriver to carefully pry out vanity mirror light at
recess -arrow-.
– Unplug electrical connector.
– Detach cover over bulb -arrow-.
– Remove bulb (12 V, 5 W) from holder on reverse side of vanity
mirror light.
Installing
Install in reverse order.
7.2 Removing and installing front interior
light with roof electronics control unit -
J528- - vehicles up to 08.2007
Special tools and workshop equipment required
♦ Removal lever - 80 - 200-
Removing
– If control unit is to be renewed, select the “Replace control unit”
function for appropriate control unit in ⇒ Vehicle diagnostic
tester.
– Continue to follow the instructions on the display of the vehicle
diagnostic tester.
– Switch off ignition and take out ignition key.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
292 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
Need help?
General
