Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Use screwdriver to pry cover cap off each wiper arm.
– Loosen nuts -arrows- several turns.
– Apply puller - T10369/1- at wiper arm -1- as shown in illustra‐
tion.
– Apply thrust piece -2- at wiper shaft.
– Turn bolt -3- clockwise until wiper arm is clear of wiper shaft.
– Remove nuts completely and detach wiper arms.
Installing
Caution
Risk of damage to body.
♦ The wiper arms for driver's and front passenger's side
have different lengths.
Installation is carried out in the reverse order; note the following:
– Adjust wiper arms ⇒ page 114 .
2.4 Adjusting wiper arms
Procedure
Note
If the wiper motor needs to be run during repair work, the bonnet
must be closed (voltage supply to wiper motor is cut off when
bonnet is open).
– Remove wiper arms ⇒ page 113 .
– Switch on ignition.
– Operate “touch-wipe function” and allow wiper motor to move
to end position.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
114 Rep. gr.92 - Windscreen wash/wipe system
To Next Page
Loading...
