Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Removing
– Switch off ignition and take out ignition key.
– Pull off rubber seal -1- for plenum chamber covers.
– Remove plenum chamber cover -2-.
Note
Disregard -item 3-.
– Unscrew bolts -2- and -3- and take alarm horn - H12- out of
plenum chamber.
– Unplug electrical connector -1-.
Installing
Install in reverse order.
Tightening torque
Component Nm
Alarm horn - H12- to bracket 4
11.4 Removing and installing interior moni‐
toring deactivation switch - E183- and
alarm system off switch - E217-
Removing
– Switch off ignition and take out ignition key.
– Carefully prise trim panel out of door trim.
– Unplug electrical connector to door warning lamp.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
316 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
