Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7.3 Renewing fog light bulb - Audi A8 from
10.2004 onwards
Removing
– Remove fog light ⇒ page 201 .
– Release retaining tabs -arrows- on cover cap -1-.
– Unplug electrical connectors -2- at bulb.
– Disengage retaining clip -1- and take bulb -3- out of housing.
Installing
Installation is carried out in the reverse order; note the following:
– Fit new bulb (H7 - 12 V, 55 W) in housing; do not touch the
glass part of the bulb with bare hands.
– Secure bulb with retaining clip.
– Plug in connectors and close housing cover.
– Adjust fog lights ⇒ page 204 .
7.4 Removing and installing fog lights - Audi
S8
Removing
– Switch off ignition and take out ignition key.
– Turn light switch to position “0”.
– Pull out air intake grille -1- in bottom section of bumper cover
-arrows-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
202 Rep. gr.94 - Lights, bulbs, switches - exterior
To Next Page
Loading...
