Audi 2003 A8 - Pin Assignment at Multi-Pin Connectors on Instrument Cluster

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.2 Pin assignment at multi-pin connectors
on instrument cluster
Multi-pin connector, 32-pin, blue
1 - Terminal 30
2 - Terminal 30
3 - Terminal 31
4 - Terminal 31
5 - Data bus diagnostic interface wake-up wire
6 - External buzzer
7 - Brake pad
8 - Oil level
9 - Radio-controlled clock signal
10 - Radio-controlled clock 5V
11 - Electromechanical parking brake 2
12 - Electromechanical parking brake 1
13 - Not used
14 - Brake fluid low
15 - Oil pressure switch
16 - Not used
17 - Terminal 58s
18 - Terminal 30
19 - Terminal 31
20 - Washer fluid low
21 - Coolant level low
22 - Fuel tank sender earth
23 - Fuel gauge sender 4 - G393- (tubular sender, right-side)
24 - Ambient temperature
25 - Fuel gauge sender 3 - G237- (tubular sender, left-side)
26 - Fuel gauge sender 2 - G169- (lever-type sender, right-side)
27 - Fuel gauge sender - G- (lever-type sender, left-side)
28 - Sender earth
29 - Data bus diagnostic interface for CAN bus High
30 - Data bus diagnostic interface for CAN bus Low
31 - MMI CAN bus High
32 - MMI CAN bus Low
Audi A8 2003 ➤
Electrical system - Edition 08.2014
1. Instrument cluster 85