Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Headlight (right-side) - vehicles with auxiliary heater:
– Unscrew bolt -arrow- for coolant pipe -1- and lock carrier.
All vehicles (continued):
– Loosen locking bolt -1- a few turns.
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
– Unscrew bolts -arrows-.
– Press ball head of actuator shaft out of its mounting by swiv‐
elling control motor -1- downwards.
– Unplug electrical connector -2-.
Installing
Installation is carried out in the reverse order; note the following:
– Start by inserting ball head of actuator shaft in mounting on
reflector from below; to do so, pull reflector to rear.
Note
The headlights must always be re-adjusted if the control motors
are removed and installed or renewed ⇒ page 151 .
– Close housing cover and secure with locking bolt.
– Install front wheel housing liner ⇒ Rep. gr. 66 .
Tightening torque
Component Nm
Control motor to headlight housing 1
Audi A8 2003 ➤
Electrical system - Edition 08.2014
4. Gas discharge headlights 171
To Next Page
Loading...
