Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Headlight (right-side) - vehicles with auxiliary heater:
– Unscrew bolt -arrow- for coolant pipe -1- and lock carrier.
All vehicles (continued):
– Loosen locking bolt -1- a few turns.
– Release retaining tabs -arrows- and detach housing cover for
dipped beam headlights from headlight housing.
– Unplug electrical connector.
– Unscrew bolts -arrows- and detach output module for head‐
light from housing cover.
– Release retaining tabs -arrows A- and press connector -1- out
of housing cover -2- -arrow B-.
– Detach housing cover.
Installing
Installation is carried out in the reverse order; note the following:
– Check seal between output module for headlight and housing
cover.
– Re-attach connector.
– Close housing cover and secure with locking bolt.
– Install front wheel housing liner ⇒ Rep. gr. 66 .
Tightening torque
Component Nm
Output module for headlight (left/right) to head‐
light
1
Audi A8 2003 ➤
Electrical system - Edition 08.2014
4. Gas discharge headlights 173
To Next Page
Loading...
