Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Installing
• Tightening torques ⇒ page 208 and ⇒ Rep. gr. 66
Installation is carried out in the reverse order; note the following:
Note
Entire turn signal in exterior mirror must be renewed as a com‐
plete unit if an LED is defective.
– Insert tip of turn signal repeater in slot in housing -3- for exterior
mirror -arrow A-.
– Swivel housing -4- for turn signal bulb into exterior mirror
housing -arrow B-; locking lug -2- must engage in mounting
-1-.
– Fit mirror glass onto mirror adjustment unit and press mirror
glass into place.
Note
When pressing on the mirror glass, apply pressure in the centre
of the mirror only.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
10. Turn signal repeaters - vehicles from 09.2007 onwards 211
To Next Page
Loading...
