Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press down adjustment surface -5- for mirror glass -arrow A-.
– Unscrew bolts -2 ... 4-.
– Release retaining clip -1- at cover.
– Pull housing upwards off cover and detach from mirror mount‐
ing -arrows B-.
– Remove bolt -arrow- for cover/mirror mounting -5-.
– Unscrew bolts -1- and -3- and disengage entry light -4- in ex‐
terior mirror at cover.
– Unplug electrical connector -2-.
Installing
Installation is carried out in the reverse order; note the following:
Note
Entire entry light in exterior mirror must be renewed as a complete
unit if LED is defective.
– Fit mirror glass onto mirror adjustment unit and press mirror
glass into place.
Note
When pressing on the mirror glass, apply pressure in the centre
of the mirror only.
Tightening torques
Component Nm
LED for entry light in exterior mirror to cover 1
Cover to mirror mounting 1
Audi A8 2003 ➤
Electrical system - Edition 08.2014
11. Entry light in exterior mirror - vehicles up to 08.2007 213
To Next Page
Loading...
