Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolt -3-.
– Disengage entry light -2- at retaining tab -1- -arrow- and re‐
move.
Installing
• Tightening torque ⇒ page 214
Installation is carried out in the reverse order; note the following:
Note
Entire entry light in exterior mirror must be renewed as a complete
unit if LED is defective.
– Fit mirror glass onto mirror adjustment unit and press mirror
glass into place.
Note
When pressing on the mirror glass, apply pressure in the centre
of the mirror only.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
12. Entry light in exterior mirror - vehicles from 09.2007 onwards 217
To Next Page
Loading...
