Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Switch off ignition and take out ignition key.
– Press button -arrow- and take out front ashtray insert -1-.
– Unscrew bolt -arrow- and remove front ashtray housing.
– Unplug electrical connector.
– Lift off switch trim for centre console -arrows-.
– Unplug electrical connectors.
– Remove bolt -3-.
– If fitted, pull out locking pin -1- -arrow-.
– Detach entry and start authorisation button - E408- / driver
identification control unit - J589- -item 2-.
Installing
Install in reverse order.
Tightening torques
Component Nm
Entry and start authorisation button - E408- or
driver identification control unit - J589- to switch
trim
0.8
Ashtray housing to centre console 2.5
Audi A8 2003 ➤
Electrical system - Edition 08.2014
288 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
