Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Press cover -1- apart slightly at both sides -arrows- and take
out humidity sender - G355- -item 2-.
Installing
Installation is carried out in the reverse order; note the following:
Note
♦
After removing centre bracket for sun visor, tapped holes for
centre bracket for sun visor must be cleaned of remaining
locking fluid. Otherwise the new bolts can seize when screw‐
ing in and they can shear off if they have to be removed again
later.
♦
Use a thread tap to clean.
♦
Renew self-locking bolts.
– Carefully insert humidity sender - G355- in side guides.
Note
If humidity sender - G355- is not installed correctly, it will not be
centred in hole in cover.
– Install interior mirror ⇒ Rep. gr. 68 .
– Install front interior light ⇒ page 293 .
Tightening torques
Component Nm
Moulded headliner to body 4
Centre bracket for sun visor to body
4
1)
•
1)
Renew bolts.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
306 Rep. gr.96 - Lights, bulbs, switches - interior
To Next Page
Loading...
