Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Release fasteners -arrows- and lift off relay and fuse holder in
electronics box.
Note
Disregard -item 1-.
– Unclip plug-in sockets for electrical multi-pin connectors.
Note
Exact assignment of contacts in relay and fuse holder in elec‐
tronics box (plenum chamber) can be found in appropriate current
flow diagram ⇒ Current flow diagrams, Electrical fault finding and
Fitting locations.
Installing
Installation is carried out in the reverse order; note the following:
Note
Refit all cable ties at the same locations when reinstalling.
– Connect battery. Steps required ⇒ page 3 .
– Adjust wiper arms ⇒ page 114 .
Tightening torque
Component Nm
Engine control unit to electronics box (plenum
chamber)
2
Audi A8 2003 ➤
Electrical system - Edition 08.2014
3. Relay carriers, fuse carriers (engine compartment) 337
To Next Page
Loading...
