Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Open cover -1-.
– Unscrew electrical wire -arrow-.
– Pry out wiring clip -arrow- using removal lever - 80 - 200- .
– Unscrew bolt -3- at earth point.
– Unscrew nut -2-.
– Loosen nut -1- one turn and detach heated windscreen control
unit - J505- with wires connected.
Installing
Installation is carried out in the reverse order; note the following:
Note
Refit all cable ties at the same locations when reinstalling.
– Install battery ⇒ page 4 .
Tightening torques
Component Nm
Heated windscreen control unit - J505- to body 5
Earth cable to body 9.5
Electrical wire to fuse holder 7.5
Audi A8 2003 ➤
Electrical system - Edition 08.2014
352 Rep. gr.97 - Wiring
To Next Page
Loading...
