Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
♦ Drip tray for workshop hoist - VAS 6208-
♦ Hose clip pliers - VAS 6362-
Removing
Note
All cable ties unfastened or cut open during removal must be re‐
attached in same position when installing.
– With ignition switched off, disconnect earth cable at battery
⇒ page 2 .
– Carefully pull the engine cover panel off the four retaining pins
one after the other -arrows-.
Audi A8 2003 ➤
Electrical system - Edition 08.2014
48 Rep. gr.27 - Starter, current supply, CCS
To Next Page
Loading...
