Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Remove bolts -4- and -6-.
– Detach electrical wires -2- and -3- at starter.
– Remove bolts -1- and -7-.
– Take out starter.
Note
Disregard -item 5-.
Installing
Installation is carried out in the reverse order; note the following:
Note
Refit all cable ties at the same locations when reinstalling.
– Install starter catalytic converter (right-side) ⇒ Rep. gr. 26 .
– Install subframe ⇒ Rep. gr. 40 .
– Connect battery. Steps required ⇒ page 3 .
Tightening torques
Component Nm
Starter to engine 42
Terminal B+ to starter 16
Terminal 50 to starter 10
Bracket for starter to engine 10
Engine support to cylinder block 42
Bracket for turbocharger
to:
Engine support 22
Turbocharger
10
1)
•
1)
Coat thread and head resting surface with high-tempera‐
ture paste; for high-temperature paste refer to ⇒ Electronic
parts catalogue .
Audi A8 2003 ➤
Electrical system - Edition 08.2014
82 Rep. gr.27 - Starter, current supply, CCS
To Next Page
Loading...
