Parameter manual b maXX BM3000
Document no.: 5.12001.07 Baumüller Nürnberg GmbH
818
of 820
Index
Set of set values 550, 554
Set specification 550
Set value generator 417
Set value handshaking 551
Set value manager 394
Set value profiles 559
Set value specification 550
SH 330
Signal
Chopper resistor on 391
Supply operationally ready 391
Signal bus 391
Sine-cosine 32, 64
Single set value 552
Single setpoint 550
Single-turn encoder 549
Smooth torque reduction 339
SoftDrivePLC 307
Software limit switch 549, 552, 557
Software modules 77
Source data set 364, 365, 367
Speed - synchronous operation 627
Speed control 399
Speed controller 441, 450
Speed preset 399
Speed profile 549
Speed profiles 559
Speed setpoint sequence 417
Start 44, 76
Start command 550
Start ProDrive 23, 55
State machine 334
Statically 549
Stop/Off 44, 76
SW limit switch 557
Switch wiring 586
SWITCHED ON 331
Switching between modes 330
Switching elements 19, 50
Switching off the drive 44, 76
SWITCH-ON INHIBIT 331
Synchronization 298
Synchronous motors 34, 66
Synchronous operation 627
synchronous position setpoint value specifi-
cation 616
System control 80
T
Target data set 364, 365
Target position 549
Target position reached 551
Target position setting 549
Target specification
absolute 557
relative 557
Target specifications 557
Temperature 723
The dwell position has been found 42, 74
Thermal load 723
Thermal time constant 724
Time zones 417
Time-optimized positioning 560
Tipping operation 603
Torque control 441
Torque Coupling 280
Torque current limiting 470
Trapezoidal profile 400, 562
Travel 549
Trigger 700
Trigger sources 700
Trigger time 700
Triggering 700
Troubleshooting 741
Two-level controller 506
output 510
with absolute thresholds 507
with relative thresholds 508
U
Up/Download 364
V
Virtual lead shaft 627
Voltage test 17, 47
W
Warning 12, 742
Warnings 12
Z
Zero angle 583, 584, 593
Zero pulse 583, 584, 593
To Next Page
Loading...
Need help?
General