Loading camera parameters from memory card
Loading a new FPGA file
Setting the sensor resolution
Network
Ethernet
IP Address
Netmask
MAC
Time Sync.
CAN Open
CAN Address
CAN Termination
Calibration Settings
Calibration Method
Resolution Pix/µm
Camera Dist. mm
Display Settings
Display Rotation
Lock Touchscreen
Set Defaults
Factory Default
Load/Store Settings
Store Settings
Load Settings
Load New FPGA File
FPGA Mode
Scaling
Pixel Resolution
Physical Unit
Network Settings
Operation in an Ethernet Network
Setting the IP address
Setting the netmask
Setting the MAC address
Selecting the synchronization method
Operation on the CAN Bus
Setting the CAN bus address
Activating the CAN bus terminating resistor
Calibration Settings
Selecting the calibration method
Setting the calibration constant
Setting the CCD camera distance to the material
Display Settings
Rotating the screen display
Locking the touchscreen
Default Settings
Restoring the factory default settings
Loading/Storing of Settings
Storing camera parameters on memory card
Loading camera parameters from memory card
Loading a new FPGA file
Selecting the FPGA mode
Scaling Settings
Setting the sensor resolution
Selecting the unit for the measured value output
Operation Display
Device Settings
To Next Page
Loading...
