6
Installation
40/198 CCD CAM 100 – Installation and Operating Manual
6 Installation
6.1 Safety Instructions
WARNING
Danger of death and material damage caused by incorrect install-
ation!
►
Have the installation carried out only by qualified personnel
that have been instructed by BST service staff or authorized per-
sonnel.
DANGER
Danger of death caused by the machine starting up!
Parts of your body could be crushed, cut, drawn in or hit.
►
Switch off the machine completely and secure it against it being
switched back on.
NOTICE
Damage to the system from drilling dust and loose parts!
Drilling dust, splitter and loose parts may damage the machine.
►
Before carrying out drilling or installation work, cover the
affected area of the machine with film or paper.
►
After installation work, check that the bolts are screwed tight.
NOTICE
Damage to the camera lens from careless handling!
Soiling or scratches to the lens.
►
Transport the CCD camera only with mounted protective filter
and protective sleeve pulled on.
Before starting with the installation work
►
Read the safety instructions in the operating instructions of the
machine in which the BST components are to be installed.
►
Observe the complete safety concept of the machine.
►
Cordon-off the work area in order to prevent access by unau-
thorized persons (e.g. by setting up barriers).
►
Make sure that all parts of the machine where the BST compon-
ents have to be installed have a sufficient load bearing capacity.
To Next Page
Loading...
