About Safety
2
CCD CAM 100 – Installation and Operating Manual 9/198
2 About Safety
The system has been designed according to the state of the art
and fulfils the latest safety standards.
When using the system, risks may occur that could threaten your
life or health or lead to material damage. In order to avoid these
risks, all instructions in this manual concerning safety and all
relevant documentation of the entire system must be observed.
2.1 Intended Use
The CCD camera is only intended for the detection of contrast
differences for the guiding of web-shaped materials and for the
web width measurement.
The system is integrated in a machine or connected with another
machine to form a machine as defined by machinery directive
2006/42/EC. All machines and the overall machine line must meet
the requirements of the machinery directive after integration of
the system.
The lamps included in this system are special products in accord-
ance with the EU Directive 1194/2012/EC, Art. 2, Paragraph 4. The
lamps are only intended for use as specified above as part of this
system. Any use other than as intended as is not permitted.
The system and all of its components are exclusively intended for
commercial use in an industrial environment.
Moreover, the system may only be started up, if the following
regulations are adhered to:
■ The product must only be installed or operated in a non-
explosive atmosphere.
■ The product and all components may only be used while in
perfect condition.
■ All safety devices must be in perfect condition.
■ The product may only be operated with the components
belonging to the system. The only third-party components
exempt from the above are those supplied by BST or explicitly
approved for use with the system.
■ Parts that are not in perfect condition must immediately be
replaced with original spare parts.
■ All work on or with the product may only be performed by
instructed and qualified personnel, see chapter Qualification of
the Personnel, page 15.
■ Always adhere to this operating manual and all safety instruc-
tions.
■ The operating conditions and performance limits indicated in
the technical data must be observed.
To Next Page
Loading...
Need help?
General
