BST CCD CAM 100 - Setting the CAN Bus Address

Operation
9
CCD CAM 100 – Installation and Operating Manual 153/198
9.9.6 Setting the CAN Bus Address
\ Network \ CAN Open \ CAN Address
If you are operating the CCD camera on the CAN bus, use the CAN
Address menu to set the CAN bus address of the device.
Address
tens
Address
ones
Fig.96: CAN Address menu
The CAN bus address set is shown in the operation display (see
Display of the CAN Bus Address, page 120).
Determining the CAN bus address of the CCD camera
The CAN bus address is made up as follows:
CAN-address = Address tens + Address ones
Address Ones
The controller allocation is carried out with address ones.
All devices with the same address ones each form a guiding
system.
Address Ones CAN Address of the Controller
x1 11
x2 12
x3 13
Address Tens
The sensor allocation is carried out with address tens.
Address Tens Sensor Allocation
2x Sensor 1
3x Sensor 2
4x Sensor 3