BST CCD CAM 100 - X70 - External Illumination

7
Electrical Connection
62/198 CCD CAM 100 – Installation and Operating Manual
7.3.3 X70 - External Illumination
The external illumination is connected to the CCD camera using a
6-pin M8 micro-style connector.
View X
Socket (female)
View X
Connector (male)
Fig.36: Contact assignment of the plug connector
Contact Function Remark
1
Illumination 1
LED1+
24V⎓, max. 500mA
2 LED1-
3
Illumination 2
LED2+
24V⎓, max. 500mA
4 LED2-
5
Illumination 3
LED3+
24V⎓, max. 500mA
6 LED3-
Do not wire the outputs in parallel.
When connecting external illumination, ensure that the
maximum current of 500 mA per output is not exceeded.
For this purpose, check the value given for the nominal
current on the name plate of the illumination source to
be connected. If the maximum current of 500 mA per
output is exceeded, you must connect the illumination
source to a separate power supply.
If you use all three illumination outputs, you must take
an increased power consumption into account when
dimensioning the supply line (length of cable and wire
cross-section) for the power supply to the CCD camera.