BST CCD CAM 100 User Manual

Commissioning
8
CCD CAM 100 – Installation and Operating Manual 71/198
8 Commissioning
8.1 Safety Instructions
WARNING
Danger of death and material damage caused by incorrect
commissioning!
►
Have the commissioning carried out by BST service personnel or
authorized personnel only.
DANGER
Danger of death caused by the machine starting up!
Parts of your body could be crushed, cut, drawn in or hit.
►
Switch off the machine completely and secure it against it being
switched back on.
WARNING
Mortal danger from guiding device movements!
During commissioning, parts of your body may be crushed, cut or
hit. Before starting with commissioning:
►
Set the operating mode Manual mode on the web guide con-
troller.
►
Make sure that no persons are in the vicinity of the pivoting/
traversing area of machine components that are positioned by
the actuator (e.g. pivoting frame guide, swivelling roller guide,
rewinder, unwinder).
►
Cordon off the work area to prevent access by unauthorised
persons.
WARNING
Eye injuries and dazzling from looking directly into the light source!
Looking directly into the lighting may lead to impaired eyesight and
subsequent accidents.
►
Never look directly into the light source when switched on!
►
Using suitable measures, make sure that direct eye contact with
the lighting is impossible.
►
Switch off the light source and wait ten minutes before carrying
out maintenance, repair, cleaning or installation work.
WARNING
Danger of burns caused by hot lamps!
Lamps and light units can cause severe burns when touched, as
they become very hot during operation and only cool down gradu-
ally after being switched off.
►
Completely switch off the system, disconnect it from the power
supply and wait for ten minutes before carrying out any main-
tenance, repair, cleaning or assembly work.
►
Secure the system against being switched on again.

BST CCD CAM 100 Specifications

General

Brand	BST
Model	CCD CAM 100
Category	Accessories
Language	English