Transport, Delivery and Storage
5
CCD CAM 100 – Installation and Operating Manual 39/198
5 Transport, Delivery and Storage
5.1 Transport
The CCD camera is classified as an optical instrument. It must be
looked after accordingly.
NOTICE
Damage to the camera lens from careless handling!
Soiling or scratches to the lens.
►
Transport the CCD camera only with mounted protective filter
and protective sleeve pulled on.
►
Transport the system components only in the original packaging
and in the position marked on the packaging.
►
Lift and put the transport goods down carefully.
5.2 Scope of Delivery
Obtain the scope of delivery from the delivery documents or
confirmation of order.
5.3 Unpacking the Delivery
1. Check the outside of the packaging for damage and make a
complaint to the supplier if necessary.
2. Carefully open the packaging.
3. Check the delivery for completeness and visible damage.
4. Store the packaging for the event that components have to be
stored or transported.
5. If components are not installed immediately, store the
components in the original packaging, see chapter Storage,
page 39.
5.4 Storage
NOTICE
Damage to the system caused by incorrect storage!
►
Never store the system and its components outdoors.
►
Adhere to the following storage conditions.
The system and components must be stored as follows:
■ In a well ventilated and dry room
■ In the original packaging
■ On palettes or on a shelf to protect against moisture on the floor
■ Protected against dust and dirt (e.g. covered with film)
►
Observe the following Conditions:
Ambient Conditions Permissible Values
Storage temperature -10 ... +70 °C (+14 ... +158 °F)
Air humidity 5 ... 90 % , non-condensing
To Next Page
Loading...