BST CCD CAM 100 User Manual

2
About Safety
12/198 CCD CAM 100 – Installation and Operating Manual
2.3 Safety Instructions
Every user must read and follow the safety instructions in these
instructions before working with or on the system.
The following contains general safety instructions that always
have to be observed. Special safety information that must be
observed for certain work will be specified at the start of the
respective chapter of these instructions.
2.3.1 General Safety Instructions
DANGER
Danger of death when operated in potentially explosive areas!
►
The system must not be installed or operated in potentially
explosive areas.
DANGER
Danger to life due to moving machine components!
Crushing, shearing, scraping, pulling in or impact injuries of body
parts may occur.
►
Never reach into the area containing moving rollers or machine
components.
►
Do not wear necklaces, scarves or similar near moving rollers/
machine components.
►
Never stay within the swivel/movement range of moving
machine components or reach into these areas.
►
Prior to set-up/operation of the system, ensure that no persons
are in the operating range of moving machine components.
DANGER
Danger to life due to electrocution!
Fatal injuries due to incomplete shut-down or residual currents.
►
If insulation defects or defects on live components occur,
immediately shut down the power supply and have the system
repaired by a qualified electrician.
►
Completely switch off the system, disconnect it from the power
supply and wait for ten minutes before carrying out any main-
tenance, repair, cleaning or assembly work.
►
Secure the system against being switched on again.
WARNING
Danger of cutting on sharp edges of the material web!
Severe cutting injuries caused by the edges of the moving material
web.
►
Never touch the edges of moving material webs.

BST CCD CAM 100 Specifications

General

Brand	BST
Model	CCD CAM 100
Category	Accessories
Language	English