About Safety
2
CCD CAM 100 – Installation and Operating Manual 13/198
WARNING
Danger of falling and damage to assets caused by stepping/climb-
ing onto components!
Stepping/climbing onto components (e.g. traverse bars or camera
housing) can lead to life-threatening falling accidents and to the
destruction of the components.
►
Never climb or step onto components.
WARNING
Danger to life due to missing Emergency Stop devices!
Severe injuries may occur, if no Emergency Stop device (Emer-
gency Stop button) is installed on the overall machine line. Only an
Emergency Stop device permits an immediate stop of the machine
line in emergencies. It is not permitted to operate the overall ma-
chine line without an Emergency Stop device.
►
If one is not already installed, have an Emergency Stop button
and Emergency Stop systems installed by the owner/user/
machine manufacturer prior to using the machine line.
WARNING
Severe injuries due to unfamiliarity with/non-observance of
Emergency Stop devices and safety information!
►
Prior to starting work, familiarize yourself with the Emergency
Stop and rescue devices of the overall machine line, e.g. Emer-
gency Stop button.
►
Prior to starting work, ensure that all safety regulations and
instructions are observed.
WARNING
Eye injuries and dazzling from looking directly into the light source!
Looking directly into the lighting may lead to impaired eyesight and
subsequent accidents.
►
Never look directly into the light source when switched on!
►
Using suitable measures, make sure that direct eye contact with
the lighting is impossible.
►
Switch off the light source and wait ten minutes before carrying
out maintenance, repair, cleaning or installation work.
WARNING
Danger of burns caused by hot lamps!
Lamps and light units can cause severe burns when touched, as
they become very hot during operation and only cool down gradu-
ally after being switched off.
►
Completely switch off the system, disconnect it from the power
supply and wait for ten minutes before carrying out any main-
tenance, repair, cleaning or assembly work.
►
Secure the system against being switched on again.
To Next Page
Loading...
Need help?
General
