Installation
6
CCD CAM 100 – Installation and Operating Manual 41/198
During installation work
►
Observe all safety instructions and hazard warnings on the BST
components and the machine.
►
Do not deactivate or remove any protection and safety equip-
ment belonging to the machine. If the protection and safety
equipment has to be removed for the installation of the BST
components, these must be re-installed immediately after
completing the installation work.
►
Escape routes and access to safety equipment must not be
blocked by the installation of BST components.
►
Make sure that no parts (e.g. screws, washers, tools) can fall
into the machine. Cover the affected area of the machine with
film or paper. Parts falling down may damage the machine.
►
Do not climb onto or walk on BST components or unsuitable
parts of the machine.
►
Ensure that there is sufficient free headroom. If the free head-
room is restricted, the relevant components causing the height
restrictions must be padded and danger-warning signs must be
attached to them (yellow / black).
After completing the installation work
►
Install all safety equipment and protective covers that had to
be removed for the installation work.
►
Check that the bolts are screwed tight.
►
Remove all tools and auxiliary aids used from the machine.
►
Before commissioning, remove any transport locks present
from the BST components.
To Next Page
Loading...
Need help?
General
